J-Link 3-Wire Case

prusaprinters

<p>I nuked a JLink clone I had when handling it bare PCB so I tried to cook up a easy case to prevent that from happening with the second one.</p> <p>The JLink clone used for this is this one.</p> <p>I added a hole for the led to shine through which you<em>could</em> put a piece of clear filament into to make a light pipe. It also has a cut out to see the pin assignments. It's held together by pieces of tape. I tried to make it snap fit but this part is too small for the resolution on my printer to do that effectively. You could also glue it if you wanted to.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Monoprice</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Select Mini</p></div> <p><strong>Rafts:</strong></p> <p>Doesn't Matter</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Infill:</strong></p> <p>15%</p> <p><strong>Filament:</strong></p> Inland PLA <p>Rainbow!</p> </p></p> Category: Electronics