J-Link 3-Wire Case

thingiverse

I fried a JLink clone when handling its bare PCB, so I created an easy case to prevent that from happening with the second one. The JLink clone used for this is a specific model available on Amazon at [this link](https://www.amazon.com/dp/B07WKWG9DD/ref=cm_sw_em_r_mt_dp_U_jhVZEbCNGZFWS). I drilled a hole in the case to allow the LED to shine through, and you could insert a piece of clear filament to create a light pipe. The case also features a cutout for viewing pin assignments. It's held together by adhesive tape. I attempted to design a snap-fit mechanism but this part is too small for my printer's resolution to achieve that effectively. You can also opt to use glue if desired.