J Hook Windshield Wiper Tip Repair Sleeve

thingiverse

I'm working on restoring an old VW Bus, and the windshield wiper arm's tip was broken off. I went to the store, bought a J-hook windshield wiper blade, and then got designing. This is a sleeve that goes on the very end of a windshield wiper arm, which will let you mount a J-hook wiper blade on it. The fit is quite snug, I didn't even need glue, but it might be better if you go with a little bit of glue to bond the windshield wiper arm and the sleeve. I put it straight up because it's the position that requires the least amount of support. You could probably print without any supports at all, but I wanted to make sure. 50% infill was strong enough for me, but if you want to be sure, go bananas and do it at 100%