Izzet Keyrune

thingiverse

Welcome to the world of discovery and science with the Izzet Guild! I left out the wires seen on the original card as modeling them would be way too difficult and most likely wouldn't print very well. That being said, I did place slots in some of the pieces jutting out of the sides that you make take some cable yourself and place them onto the key. Approximately 9" from tip to tip. There are files for the complete model as well as the separate pieces (if, like me, your printer doesn't print very big. :P) I hope you enjoy! Printer Settings: Elegoo Mars: Settings using Translucent Standard Photopolymer Resin (Elegoo) Layer Height 0.04 Bottom Layer Count: 7 Bottom Exposure Time: 75s Bottom Lift Distance: 4mm Lifting Distance: 4mm Bottom Lift Speed: 20mm/min Lifting Speed: 40mm/min Retract Speed: 150 mm/min Infill: None.