ITX open frame case with ATX PSU

thingiverse

This is an ITX pc case which fits an ATX PSU and standard ITX parts. )The PSU is mounted with three standard pc case screws. )The mainboard needs standoffs first. These need to be melted into the plastic with a soldering iron for maximum strength. Then just use four standard mainboard screws to mount it. )The graphicscard mount is far from thought out and needs a remake to allow faster swapping of the card. The current version works as intended. Although assembling is a bit tricky. You need two pc case screws (the same as used with the PSU) and a couple of M3*30, M3*20 and M3*16 screws with washers for the mount. )a riser cable is needed to connect the GPU to the mainboard. 20cm is a great length in my opinion. I designed the case to be printed on a Longer LK5 pro. Thats why the main body is only one big part with the GPU mount seperated for faster printing. That way the case is more sturdy but also incompatible with most smaller printers. You need at least 183x184x348.5mm clearence or redesign it so it will fit. Printing settings: Printer: Longer LK5 pro Layer hight: 0.3mm Print speed: 100mm/s Support: yes (only for the PSU screw slots) Infill: 20% (more is better but it even works great with 10%) Print time: about 20 hours At the moment there are two Versions available. Version 1 (V1) and Version 2 (V2). Both work but still have their flaws with the GPU mount. I´d recommend going with V2 till i release V3. Currently working on a third & better version. Hope to release it soon(TM) Hope you enjoy