IStick Pico Honeycomb Case

thingiverse

I wanted a protective case for my awesome little vape, but the ones I found didn't work for me because they lacked the grip I needed, so I designed this case in Fusion 360 over three days and it turned out amazing. I'm excited to share it with my fellow Pico users. You might need to sand the inside a bit to smooth it out since this is a snug fit. To make the case, I recommend printing three perimeters because I had issues with two perimeters (the printer would print infill in 3mm lines and then do the perimeter, but eventually fail, resulting in a messy print). I printed the case without supports at 0.16 layer height and 15% infill to make it look cool, while the fire button and adapter ring were printed at 0.08 layer height and 45% infill to give them a sleek appearance. I added an adapter ring because I use a Berserker MTL RTA and needed a cooling system adapter that looked ridiculous on its own, so I spent three minutes in Fusion 360 and created something much better. By the way, this adapter needs to be rotated 180 degrees.