ISP-10p-6p AMTEK adapter suite e.g. for Ender3

prusaprinters

If you like to update your printer's firmware and it doesn't work via USB port the motherboard doesn't have the bootloader installed. Also if your board just doesn't have enough program space you can upload the firmware directly via ISP and save those precious bytes. Here's 10p & 6p ISP/JTAG plugs with narrow ISP 6p one allowing to connect 6pin header of Ender3 board (as it is in a bit thigh place next to display connector). Obviously you can also make your own 10p to 6p ISP adapter out of the pieces. You'll need thin wire (single 0.129mm2/AWG26 suits OK) Peel wire end 5-7mm, bend J-form, put pure wire end in to the hole and pull unpeeled section via outer side track under the cap. Print Settings Rafts: Doesn't Matter Supports: NoResolution: 0.2x0.4 Infill: 10% Notes: Print standing up solid ares on the bed. (sorry about orientation) Use some (-0.05>) negative horizontal expansion to keep pinholes open Category: 3D Printer Accessories