ISDT Discharger parallel board with 6 XT60 Ports

thingiverse

Parallel Board for ISDT Discharger with Six XT60 Ports - A Simple Solution for Discharging Multiple LiPo Batteries at Once. I decided to take my battery discharge capabilities to the next level by creating a parallel board that allows me to discharge multiple LiPo batteries simultaneously, no matter what the weather or plans may bring. To achieve this, I purchased two ISDT dischargers and connected them in parallel using XT60 connectors. The process is straightforward: solder two exposed copper wires to each connector, which will then be attached to the main connector on the board. Since the connections will be enclosed within a protective casing, there's no need to insulate anything. However, make sure that the wire can handle up to 6 amps of current, as this will determine its diameter. Once the connections are made, you can seal the enclosure permanently using CA glue or small screws through the mounting holes provided. When attaching XT60 connectors, apply a few drops of CA glue from the inside to secure them in place. My own print may not look perfect due to my decision to use CA glue on the outside and paint it with black primer afterwards, but I was able to reuse old XT60 connectors from previous projects. If you find this design useful, be sure to like and share it with others who may benefit from it. Happy printing!