IronMan Start/Stop Cover

prusaprinters

0.1mm layer, 2mm Brim & 20% support, 15% infill. Run printer a little slower(85%) Props to scottyboy1129 for model 360747 File and Prints of models not to sell or resale Print Settings Printer: gMax Xt+ Rafts: No Supports: Yes Resolution: 0.1 Infill: 15% Filament: JMO Technology PLA Red Notes: I tried a new filament and not happy with it. Another filament would work better. Printed 0.1mm layer w/ a 2mm brim, 20% support & 15% infill. Slow your printer down to about 85% feed rate. I used a paper clip heated to open the hinge holes, then cut a piece of the clip to use as the pin. Last, use thin double sided tape applied to the back of the ring & trimmed accordingly. Category: Automotive