Iron Maiden spiked male chastity device padlock

thingiverse

Wear this device at your own risk. This is a plastic version of the punishment / torture chastity cage with a series of internal spikes, taking its name from the Iron Maiden. It is printed in 3 parts, a ring, the base and the cover. The ring can either be a standard flat ring or a curved ergonomic ring. The front of the cover has a lip on which fits into a recess in the base keeping that in position. The rear of the cover is held in place by the padlock shaft with the base. The tube is locked onto the ring with a small padlock with a 2.5mm to 3mm hasp. The dimensions are: Rings, 46mm inside diameter with 8mm diameter for the rod giving 62mm outside diameter. Cage, 39mm inside the tube with 5mm spikes giving 29mm inside the spikes. The spikes are about 1mm diameter at the tip and 6mm at the base. They are pointed but not needle sharp. The inside length of the tube is 75mm which with the 8mm ring and 9mm ring to tube gap gives a total length of around 92mm. The outside of the tube is 44mm diameter. There are two versions of the base and cover. One version has spikes all the way down the tube covering the sensitive head with punishment spikes. There is a version with spikes at the rear / entrance of the tube only to act as anti pullout devices and this is much less punishing. These are the listed as the 39mm base and cover in the file names. I also have a version of this for use with an integrated lock / magic lock rather than the padlock version here. UPDATED 16/02/2020 I have increased the overlap on the lip at the head end of the cage and cover to keep that in more firmly in place. UPDATED 21/06/2020 After a request I have added larger 60mm ID rings. I have not printed and tested these, but they should be OK as the change was small (!!!). After a request, I have added a spike free tube, this does not need to be made as two parts. The inside length of the tube is 75mm which with the 8mm ring and 9mm ring to tube gap gives a total length of around 92mm. The tube is about 39mm inside diameter and 44mm outside diameter. After a request I have added tube designs with spikes only at the entrance to the tube to act as anti pullout measures. UPDATED 29/08/2020 After a request I have added 50mm ID rings. I have not printed and tested these, but they should be OK as the change was small (!!!). After a request, I have added a slightly larger tube. The inside length of the tube is 82mm which with the 8mm ring and 9mm ring to tube gap gives a total length of around 99mm. The tube is about 43mm inside diameter and 48mm outside diameter with 5.5mm spikes giving 32mm inside the spikes. This is the listed as the 42mm base and cover in the file names. This has not been printed so please be aware of this.