IR Head Tracking "Cap Version"

thingiverse

This is an adapted version of Crispy001's "FreeTrack 3 Point Hat Model". I estimated that the original design would require around 2 hours to complete and possibly necessitate the use of supports. I've made some adjustments to make the model easily printable in two parts without requiring supports, as well as reducing the print time to approximately 30 minutes when printed at a speed of 0.3. Furthermore, I have incorporated grooves where wires can rest, and also created a pathway inside the L piece for the wires to ascend up to the top LED. Additionally, I applied some hot glue to hold the wires in place; appearance is not as crucial as functionality here! I pay tribute to Crispy001 for creating the original design. Instructions This design has been tailored so that you can feed the wires through the L piece to the two front left and right LEDs. It should be feasible to push the wires through to maintain cable neatness and organization. I recommend dropping a dab of hot glue into the hole before inserting the L piece to prevent it from separating later. I also suggest reviewing this link below for guidance on which LEDs and Resistors are required, as IR LED voltages/amps etc may vary: http://www.free-track.net/english/hardware/calcled If you have any inquiries, feel free to send me a message. ~ iTrooper