IR emitter (and reciever) box

prusaprinters

<p>Sometimes you have a rack full of equipment (cable boxes, etc.) that each need their own IR emitter for control, but allot of times these IR emitter's don't stick so well, or get removed/broken when the equipment/cable box gets replaced by the cable guy, or rebooted by the customer, or something else.</p><p>The solution I've come up with is to cable tie the IR emitter in this 3D printed box, which magnetically mounts to the shelf and stays in-front of the equipment it's controlling.</p><p>The arrow ontop of the box should match an arrow sticker or mark you apply to the equipment so it can be re-aligned easily by anyone.</p><p>There is also a place to mount an IR receiver, in-case that same IR emitter is to control another device or something over an HDbT link, such as a TV or equipment in a certain room.</p><p>On the right side, simply snip the plastic to allow for the cable(s) to exit the box.</p><p>&nbsp;- many cable tie positions<br>&nbsp;- two IR RX holders depending on angle/position you need<br>&nbsp;- two positions for magnets to be inserted in the bottom<br>&nbsp;- cover should fit snugly on top without glue</p>