IQOS Charging Stand

prusaprinters

<p>This IQOS charging stand can fit wider models than the ILUMA One.</p><p>This model <strong>DOES</strong> need <i>supports</i>! &nbsp;Recommend using the <strong>tree type support</strong> at <strong>10%</strong> support density.</p><p>Slice this design in the upright position and it will print fine. &nbsp;Can fit on the Ender 3.</p><p>When printing the “<strong>IQOS Letters</strong>”, ensure you have the slicing setting “Wall Line Count” at 1 and at 100% Infill in order to fit properly into the model without cracking or breaking.</p><p>Placing the door in the body is a very tight squeeze but not impossible. &nbsp;Turn the “<strong>IQOS CS Body</strong>” upside down. &nbsp;Set the door at the bottom and turn it 30 degrees with the notches touching the insides of the walls. &nbsp;Once you have it in tight, you can hit it downwards until the notches catch its designated holes. &nbsp;It should be very simple to get it in from there.</p><p>I hope you all will enjoy this model!</p>