IQOS 2.4 holder replacement

thingiverse

I cracked a small dent in my IQOS charger holder. I've created a replacement that's an effortless swap from the previous decorative band on top. There are two versions: v5 and V6. v5: This one is working perfectly for me, as seen in the photo. V6: It has a slightly thicker dent (+0.1mm). I haven't tested it yet, but it should work even better. This replacement part is designed to replace your existing holder if you broke yours. Installation Instructions: - Check if the printed part fits your battery holder (I'm not sure if there are multiple models and if this component works with them) - The dent was not included in this design. Make sure it's a good fit or clean up any debris (it depends on how your dent was damaged. Be careful, I'm not responsible) - Glue the new part over the old one That's all. The fix has worked well for me. Maybe it can help you too. Don't blame me if it doesn't work as expected, but feel free to share any suggestions you might have.