iPod Touch 5th Gen Tripod Mount

thingiverse

Phone Holder with Phone Inset Mount and Credit Card Slot. Made for a case with width of six point one inches, height of twenty, holder width of five, holder height of forty and base width of forty. Here is the assembly procedure. Using a craft knife or coping saw cut out two equal shapes of five point four eight by one seven two using this plan: The credit card slot is cut as wide as possible without compromising structural integrity. This will prevent damage to both the card itself and your case. Once complete, you should see three separate components; top inset, phone insert mount, and card cut out. Attach all the three pieces together, make sure to ensure that each joint has an equal amount of pressure. Cut the end caps with craft knife or coping saw so they fit snug on the holder. Secure the end caps to both ends, tighten up using your preferred technique. Phone Holder Ready to Use. **Warning** Due to some errors, phone and card may still move a bit in your holder. Make sure it has enough friction.