Ipod 5th Gen Video 60G Minimal Case

prusaprinters

<p>As you all know, ipods are the slipperiest devices on planet earth, and i liked icomputer7's bumper case. Thin, unobtrusive, but the back of it was prone to breaking off because of a weak point in the walls where they connect to the base, so i just added a fillet that fits within the radius of the ipod's curve. Also shortened the face a little so it didnt stick out so much. This case is intended for the "fat" 60Gb iPod.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Tiertime</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Up300</p></div> <p><strong>Rafts:</strong></p> <p>Doesn't Matter</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>0.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>25%</p></div> <p><strong>Filament:</strong> any PLA <br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>pretty simple design, might want to turn on thin wall support or lower the extrusion width so you get good strong thin walls.</p></div> </p></p></p> Category: Audio