iPhone6Plus & Apple Watch Charging Stand

thingiverse

I Created the Model in SolidEdgeST10. I Only Built "Base-0_001.stl", But Made Changes to Allow Access to Side Buttons and Headphone Jack with "Base-Revision-0_001.stl". This Revision Allows for Easy Access, But Note that I Haven't Printed It Yet. Layer Height: 0.15mm Approximately 44m of Filament Used 20% Infill, No Supports Needed 17 Hours, 12 Minutes to Print the Model Nozzle Temperature: 200°C Bed Temperature: 65°C As Printed, the Apple Watch Charging Puck Fit Perfectly. However, the Phone Charging Cable Did Not Fit Properly and Had to Be Modified with a Drill. The Revision File Includes a Hole That Is Approximately 0.010" Wider in Both Directions to Minimize Any Required Modifications.