iPhone13/14 phone holder for Toyota GR-Yaris, left/right hand drive
prusaprinters
Disclaimer: Using phone holders/stands in a car is prohibited by traffic regulations in some countries. Use on your own risk. Phone widthThis holder component fits iPhone 13/14 case width about 75.5 ~ 76mm. Slightly scale the holder in the width direction still works.The width test component is a small section of the holder component for a quick test fitting. Scale the width test in the width direction and print it until it fits your phone case. Apply the same scale ratio to the holder. MaterialsABS or ASA filament (PLA is not recommended for its low temperature in a car scenario)Bolt M5 x 45 (1)Bolt M3 x 15 (2)Hex nut M5 (1)Square nut M3 (2. Hex nuts are applicable but could spin more easily)Washer M3 x 8 x 1.0 (2)Polyurethane sticky pad 6cm x 8cm3M VHB tape SlicerFor right-hand-drive users, just mirror the joint in the slicer. The other 2 components are symmetrical.Wall: 1.6mm or thickerInfill: 20% or moreUse supports.
With this file you will be able to print iPhone13/14 phone holder for Toyota GR-Yaris, left/right hand drive with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on iPhone13/14 phone holder for Toyota GR-Yaris, left/right hand drive.