iPhone to camera mount/case

thingiverse

I made an adapter for a small 2x telescope I had laying around, to fit onto an iPhone X as a case. The telescope mount is just a push fit with the opening at 44.5mm wide and 16mm tall, with a 1.18 degree taper narrowing (43.8mm at its narrowest point) towards the back of the phone case. This is a fairly simple print, but some things I changed in Cura are as follows; - Flipped it 180 degrees so that the adapter is pointing up. - Printed with conical supports (40degrees). - Reduced support density to %12 (Difficult to remove otherwise). - Used the concentric pattern for support interface.