iPhone Magsafe + Apple Watch wireless charging stand

prusaprinters

<p>Based largely on <a href="https://www.printables.com/social/87801-fanboy/about">Fanboy</a>'s <a href="https://www.printables.com/model/82527-fanboy-gen-1-apple-watch-iphone-stand-airpods-char">Gen 1 phone/watch stand</a>. I recreated the basic base shape in Fusion360 and designed the top half to hold the official Apple Magsafe charger. I also referred to a couple of online designs for the screw-retention holding section for the magsafe puck.<br><br>Printed in PLA with 0.2 layer height 30% infill, with support enforcers, and modifiers to make the lower section heavier (higher infill at 80%)<br><br>With my iPhone 13 mini, I need to either use two hands to detach the phone from the magnet hold, or lever it off by pulling with some lateral force (slide/angle the phone off). It's fine, but would be better if the base had greater weighting.<br><br>The tolerances on the Apple Watch charger area bit too loose, but the stand works, and the watch doesn't pull out the charger. The screw-locking mechanism for the base needs refinement - it's too tight and difficult to remove the supports currently.<br><br>I used three little short HDD screws (#6-32 UNC countersunk &nbsp;screws) I had to hand, although the fit is tight enough that the design doesn't require them.<br><br>But it printed well in two parts and the prototype worked first time - so I am publishing this and will update after refinements.<br><br>&nbsp;</p>