iPhone Holder for Mini Cooper vehicles

thingiverse

This will replace the Ashtray in your Classic Mini. --Box-- Use six M2.5 x 15mm screws to attach the front to the main Box. You'll also need to cut the thread into the Box right here. --Slider-- Attach the small slider to the box using one M3 x 15mm screw. It's best to use a locknut from below, but not too tight so it slides in and out easily. Use three M4 x 10mm screws to attach the Phone Holder to the Slider, making sure to cut an M4 thread into the Slider first. To connect the two sliders, I used a piece of 3mm Filament that I had on hand. --Mount to Mini-- Once assembled, push the slider all the way in and mount the box to your Mini. That's it! I only made this holder for my iPhone, but you can create your own adapter to suit your Phone. The three mounting screws are spaced 15mm apart. You can also check out a spin-off of this design called EMPY BOX at http://www.thingiverse.com/thing:2207925 Print Settings: Printer: RF1000 Rafts: No Supports: No Resolution: 0.2mm Infill: 30% Notes: Use ABS, as it can get hot in a car. PLA is not recommended.