iPhone 6s Plus stand

thingiverse

Here is a stand with recess on bottom to attach rubber/silicone feet if desired and relief for speaker and charger. I found the feet help it not slide so easy but sometimes I like it to slide easy. A regular 6s iPhone shown but will accommodate 6s plus with protective case up to 3.26 inches wide. I printed this both on a CR-10 S4 and a FlashForge creator Pro (left extruder). Used S3D slicer on the CR-10, Used FlashPrint slicer to print on the FF pro. PLA 1.75mm is used for printing. The FF Creator pro .x3g file I printed on the stand on its side provides better results for the recessed feet and the speaker relief oval shaped hole. I used a raft but don't believe it's necessary, as there is a large surface area on its side. Printing upright might advise a raft or brim, but up to you. The 6plus2stand.gcode file was used on my CR-10 S4 and worked great. Print settings: PLA 1.75, with raft, printed in upright position, fan off layer 1, 50% fan at layer 2, 100% fan at layer 5 and on. .20mm layer height, first layer speed 50%, first layer height 80%, 50% infill, internal fill pattern Grid, external pattern Rectilinear, bed 60C, nozzle 205C, print speed 2400 mm/min.