iPhone 6 tripod mount

myminifactory

I loved entomophile's remix of my previous tripod mount design. I had some spare M5x45 hex head screws from another project, so I decided to put one to good use on a new tripod mount. Sized for an iPhone 6, it may also work with other phones. A Fusion 360 file is included if you want to resize the mount. For more details, see the instructions below. Update: Version 2 adds a side mount nut option for portrait mode. Instructions: The main base file can be printed without any supports at all. It uses some modeling tricks that assume a .20 mm layer height. Screw holes are blocked with a single layer membrane to allow them to print without support; after printing, simply drill through those areas. Alternatively, you can pick out the filament with tweezers easily enough. The files are oriented as they came out of the modeler, so be sure to reorient them for printing. The knob should be printed upside down with support. This design requires an M5x45 screw, an M5 nut which goes into the nut trap in the middle, and a 1/4-20 nut for a tripod bolt which should be glued into the exterior nut-shaped hole.