iPhone 6 stand

thingiverse

This design is optimized for an iPhone 6, created using 123D design specifically. It took about one hour to print at a density of 30% and layer height of 0.2mm, consuming approximately 4.5 meters of ABS plastic in the process. I place this stand on my desk while working on my computer, allowing me to easily glance at notifications without having to pick up my device. Suggestions: Coat the plastic with epoxy glue for a glossy finish and enhanced durability, making sure it's fully dry to avoid the phone sticking to the stand. Use raft support to prevent plastic bending during printing. Apply glue when assembling the rods for added stability. Utilize acetone on the rods to remove excess plastic layers if they don't fit snugly into the holes. Print Settings: Printer: XYZ Da Vinci 1.0a Rafts: Yes Supports: No Resolution: 200 microns Infill: 30%