iPhone 6/6S Case both PLA and Flexible (ninjaflex) version

pinshape

Good News for Pokemon fans! We're thrilled to share some exciting news with you! Due to the massive popularity of PokemonGO, my brother and I designed an Articuno (team blue) iPhone 6/6S case that's sure to impress. Our team is made up of a graphic designer who crafted the unique patterns on the back of the case. These designs perfectly match the style of Articuno while still providing top-notch protection for your phone. We've worked hard to perfect our design, making two versions: one for normal material (PLA and ABS) and another for flexible material (printed with Ninjaflex). We even tested some early prototypes on ourselves and friends to catch any minor issues before they became big problems. After over 20 redesigns, we're proud to say that our cases fit perfectly, provide excellent protection, and are incredibly comfortable to use. They won't cut your fingers after long-term use, either! If you buy the pack, you'll get both the normal version and the flexible version for your iPhone. And here's what we guarantee: almost every friend of yours will notice and admire how cool your iPhone case looks. We're excited about the response so far, and if there's enough interest, we'll also create Zapdos (team yellow) and Moltres (team red) cases. Our printer is an Ultimaker 2, and here are the settings we used for each version: **Normal Version:** * Nozzle diameter: 0.4 mm * Material: PLA (ABS should work well too) * Hot end: 215 C * Layer height: 0.15 mm * Wall thickness: 0.8 mm * Speed: 35mm/s * Infill: 40% (this doesn't matter much) * Support: off * Size: 100% for iPhone 6, increase by 0.5% for perfect fit on iPhone 6S **Flexible Version:** * Nozzle diameter: 0.4 mm (0.6 or 0.8 mm might work too) * Material: Ninjaflex Cheetah (we also tried Ninjaflex Semiflex, Ninjaflex, and Flexifil PLA – they all worked fine) * Layer height: 0.15 mm * Hot end: 225 C * Layer height: 0.25 mm (this creates a smooth surface; lower heights like 0.15mm result in a matte finish) * Wall thickness: 0.8 mm * Speed: 40mm/s * Infill: 40% (again, this doesn't matter much) * Support: on * Size: 100%