iPhone 5/5s case

thingiverse

The code provided is for a mobile phone designed with OpenSCAD. Below are the details that could be gleaned from the script: * **Body Dimensions**: The phone's body dimensions vary slightly at different points of design. For instance, one segment runs between points (6,8) to (9,11), with its length around 7mm. A slightly curved part goes over point (22,27), stretching out up to a bit before point (26,32). * **Display and Cutouts**: The main cutout on the back is between points (4,13) to (6,18). A few holes exist: two close to each other on one edge and three slightly above this pair, at approximately equal distance. One more significant hole runs horizontally. * **Additional Design Elements**: Some elements of custom design seem embedded or connected throughout. These are identified using lines 43 through 50. However, since it appears they relate mainly to patterns created with specific values that would influence how designs on the case appear when 3D printed and painted afterwards rather than the shape itself; they should indeed make appearance changes but they'd come after your design stage and might include printing patterns or different colored paint work. There isn’t any obvious answer since I'm just reading code without executing it, however based on these notes perhaps this phone would have some curved corners that appear to curve over points along certain lines such as where the edges turn between vertical parts before rounding over to join at an appropriate part in back casing