iphone 4s horse z

thingiverse

Customized version of Thingiverse Thing #58001 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=58001 Instructions Using the following settings: Width between corner ribs (4cornerR) = 8 Distance from top and bottom of phone (5swidth) = 6.1 inches Height between screen and bottom of phone (4height) = 9.5 millimeters Image rotation: 0 degrees Starting at the second picture index (index_j) = 0, going to first image in a set (index_i) = 1 Design shape option (pattern_shape) = 6 Distance from the inside of a 45-degree angle cut in a flat bottom design (5_perimeter_tolerance) = .5 mm Height tolerance (5_height_tolerance) = .2 mm Minimum height for each layer of a mesh (4_height_tolerance) = .2 millimeters Total length between the edges on a bottomless design (5length) = 123.8 inches Pattern rotation = 13 degrees Perimeter tolerance (4_perimeter_tolerance) = .5 inch Thickness option (primary_color) = red Vertical position from bottom edge of base case (offY) = 0 Horizontal position offset from center of device (offX) = 0 Case width (4width) = 58.55 mm Selects one of three design cases (type_of_case) = 1 Apple iPhone model version = 1 Random pattern combination setting (mashup_type) = 1 Design pattern layer thickness (pattern_thickness) = 5 mm Top to bottom length between edges (5height) = 7.6 mm Length of side walls between edge cuts on a flat design (4length) = 115.25 mm Distance from the outside and inside edge where a cut begins (5cornerR) = 8 mm Edge curve radius for each layer in pattern designs (pattern_radius) = 17 millimeters Width setting with four layers at one point above phone screen height (4swidth) = 6.17 mm Maximum height on flat cases that can be reduced from the start without causing a change (5sthick) = 1.0 mm Insert optional features called "hooks" or include none = no Percentage to define overlapping shapes on pattern designs (pattern_overlap) = 18% Distance between center lines in width at point one inch from top screen surface where it's reduced, in units of device height that is .0008 * device width (5width) = 58.6 mm Angle of taper in a bottomless case, measured to a tenth degree angle below design max height setting on standard cases only for those having four side walls; all other styles and heights should use the same tapered cut at both edges, so this must also be changed, as a separate input value (case_taper) = 3 degrees Custom picture scaling percentage option = 100% Maximum height reduction or taper option = 1.8 mm