iPhone 12 Mini - Bike Holder

thingiverse

I designed this iphone 12 mini bike holder for a phone with apple leather case on a 25 mm handlebar. It provides a hole for a power connector in the case you would like to use a power bar for longer trips and two little holes to drain rain water. You need a 4x30mm screw to install. The holder fits pretty tide, but not too tide to scratch your case. Please check carfully! Due to tolerances of your printer your apple case might get scratched. If you think the holder is too tight or to loose, you might play just with the X or Y axis by 1/2 % (depending how the part is positioned on you printer table). When installing on the 25 mm handlebar, you might have to remove the grips to push the holder on the rod, or you need a handlebar that is partial <20 mm, otherwise the holder will brack. I also do not recommend this holder for mountainbike use, to prevent the phone from falling out of the holder you might use an additional rubber band. If you print the holder upside down you need some support online, see attached slicer screenshot The version "rounded" got rounded edges at the bottom, following the form of an iphone