Iphone 12 and Apple Watch stand

thingiverse

Remixed it -to allow an strap apple watch band to charge since base is bigger than typical strap bands -made the watch charger more of press fit which allows it to sit a little further out -Modified the lid to remove the Apple logo and made it a little thicker so it would fit in the slot a little better -cut a hole in the middle below the the phone charger so the wire could route directly out the back, do not print with supports in the middle as it will be a challenge to remove supports I would print with supports for the watch charger section. One tip, I would add is use a little Silicone sealant to the phone plug to keep it place. All the Credit really goes to sgonzalezlopez as this design even works on Iphone 12 and with a case on it as well and just sits perfectly! Thank you for your initial design!