iPad Pro 12.9" cymbal stand mount

thingiverse

I had to attach this iPad holder to a cymbal stand. I made it happen by adding an extension to the mic stand mount and filling the hole meant for threads with glue. Once that was done, I found out that the only fragile part of this design is the center stud. Because of its thinness, the top bracket was going to snap across the layer lines. Fortunately, it did break. To get around that problem, I recreated the center stud to accept a M8 x 30mm hex bolt and nut. Then I turned the breakable section into its own part that slides into the cymbal stand mount and screws on with another M8x30 hex bolt. This build requires all of the original design except for the center stud and mic stand mount. If you want to adjust the angle in two places instead of just one, print a second large tension wheel for the mounting bolts.