iOptron - Tri-Pier Mount Remote Holder

thingiverse

This is a iOptron mount control holder made for the Tri-Pier. It is made to go into the middle slot on a Tri-Pier leg and to hold the remote for the mount. There are 4 STL files in the package. <ul> <li>2 are for the <b>Middle</b> hole on the Tri-Pier leg</li> <li><ul> <li>One is <b>Firm</b> which means it hold the remote through in the center</li> <li>One is <b>Loose</b> which means it holds the remote by the bottom loosely</li> </ul></li> <li>2 are for the <b>Top</b> hole on the Tri-Pier leg</li> <li><ul> <li>One is <b>Firm</b> which means it hold the remote through in the center</li> <li>One is <b>Loose</b> which means it holds the remote by the bottom loosely</li> </ul></li> </ul> Firm - To place the remote into this holder you will need to put one end into the holder and snap the other side into the holder. To remove, push the remote to one side of the holder and snap the other side out of the holder. Loose - This one you just place the remote into the holder by the bottom until it stops. To remove just pull the remote up out of the holder. I sure hope that it clear as mud.... Sorry if I can't make it cleared, but once you try it, you will understand...