Inverted cable duct corner part

prusaprinters

<p>Because the cables from my Prusa to the PSU are a little to short, I was unable to use the Corner Part with the Cable duct as intended (By default it is positioned to the outside border of the Ikea Lack table).<br><br>For my setup, I came up with a solution, that simply inverts the position of the cable duct. The part that is attached to the “floor” can just be rotated 180 degrees and need no reprint.<br><br>The top part that is attached to the lid can not be rotated, because the guides for the plexi walls are not rotatable. So I simply created a new part, where the duct is moved/inverted to the inside of the enclosure, to match with the rotated floor part.<br><br>The printing is not different to the original part. It should be printable without any supports. I added some below the plexi guides,, but they are not necessary.</p><p>&nbsp;</p><p>I dont know why, but the original step file is modified was also inverted diagonaly. Because of that I ended up with a corner part where the cable duct was in the wrong direction. For me it was no problem to rearange the cables and I decided to use that part and not print a new one. I uploaded both the “correct” and the "wrong" file here.</p>