Intrepid Board Game Token/Cube Holder & Friction Clip
thingiverse
Intrepid comes with organisers for most of the components and the cubes & strain/disabled tokens have an area but not one that would keep them in place when moving the box around or standing it on end. This little organiser takes up just one of the token/cube/card bays and holds all the cubes and both stacks of tokens and the lid finishes flush with the top of the plastic tray for the dice trays to go above. The lid tucks under the angled section on the main body then is held in place with magnets - you can either use 2 no. 4mm x 2mm; 1 in the body and one in the lid - or what I did was use 3 no. 4mm x 1.5mm - 2 glued together in the lid so they protrude slightly and one in the body which leaves an indent the projecting ones can latch into. The print is a bit rough as it was done high speed to check final dimension fit. Should print without support just fine. I've just added a quick fix clip that can go on the side of the resource boards to stop them spinning so freely. the back face is 1.2mm roughly the same thickness as the back of the white pin so it will still lay flat. The front has a small tab which clips into the edge of the player card area and stops it moving when the dial is spun. If you push the clip right to the top it does not interfere with the solo cube holes. Prints fine without support or brim.
With this file you will be able to print Intrepid Board Game Token/Cube Holder & Friction Clip with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Intrepid Board Game Token/Cube Holder & Friction Clip.