Intex Corner Joint

thingiverse

So our Intex pool "gave in" this summer (maybe I was a bit rough on it...), and spares were nowhere to be had. So I designed my own, with additional reinforcement, to be printed in PETG. Vertical tube diameter: 32 mm Horizontal tube diameter: 38 mm Included are both the corner joint and pins. Print upside down on the big flat surface. Filament: 1.75 mm PETG (alternatively ABS) Layer Height: 0.2 mm Wall Line Count: 4 Top Layers: 4 Bottom Layers: 6 (the flat surface that will be facing up on the finished print) Infill: 30% Printing Temperature: 245 C Build Plate Temperature: 75 C Print Speed: 60 mm/s Initial Layer Speed: 10 mm/s Fan Speed: 50% Brim: Yes