Internet Button Case

Wall mountable case for the Particle Internet Button.
This is marked a "Work-In-Progress" because the clear dome isn't held in by anything so the only way to make sure it stays on completely is to have the USB cable come out the top. I need to figure out something better so I can have it come out the bottom without the dome falling off.
There's probably no reason to actually customize this, but I figured there was no reason not to make it possible. Also, come on Makerbot peeps "the internet" ≢ "chrome", make the customizer work in Firefox.
Post-Printing
When you mount it to the wall, put the screw holes at a 45° angle to avoid stuff on the bottom of the board. (Assuming you want the USB cable coming out at a right angle.)