International 25mm End Cap

thingiverse

Created a 25mm End Cap for moving wires away from the belt with ease. Printed it out with a raft and some extra support to make sure it turns out just right. Added a brand new 23mm ID End Cap, which I was excited to put into action. Installed fresh Stainless Steel round tubes that had thicker walls than before, so I designed an entirely new End Cap for them - one with an inner diameter of 22.5mm. No support needed when printing these ones out. Print Settings: Printer: Ormerod 2 Rafts: Yes, that's right, we're using a raft to make sure everything adheres properly. Supports: Yes, some extra support is always a good idea, just in case. Resolution: We're going with 0.2 for this one, nice and precise. Infill: At 15%, our infill should be just right - not too dense, but still strong. Notes: The 23mm end cap requires no support at all.