Interlocking MTG Drawers

thingiverse

This is a remix of SenpaiCZ's Modular MTG Drawer, I extended the size of the model to be just under the maximum size my printer could handle (5.46 inches height). I also added a Colorless and Multicolor design, and included my version of the blank drawer. Note: These drawers are designed for sleeveless cards. I have printed the White, Blue, Green, and Red files so far, using the settings below, the outer drawer piece takes about 33 hours, and the inner drawer piece takes about 13 hours. Slicing engine: Cura 15.04 Layer Height: 0.08 inches First Layer Height: 0.12 inches First Layer Width Factor: 100 % Shell Thickness: 0.047 inches Solid Top: Yes Solid Bottom: Yes Fill Density: 20% Bottom/Top Thickness: 0.0315 inches Print Speed: 11.8 in/s Infill Speed: 27.6 in/s Bottom Layer Speed: 7.9 in/s Skirt Minimal Length: 11.83 inches Support: Everywhere Support Type: Lines Support Angle: 70 degrees Plat. Adhesion: None Support For Dual Extrusion: Both Filament Diameter: 0.069 inches Filament Flow: 100% Print Temperature: 392 degrees F Print Bed Temperature: 158 degrees F Enable Fan: Yes Minimum Layer Cooling Time: 12 seconds Minimum Cooling Feedrate: 2.76 in/s Enable Retraction: Yes Enable Combing: All Wipe Tower: No Ooze Shield: No Cooling Head Lift: No Infill prints after perimeters: No Spiral Vase: No Only follow mesh surface: No Nozzle Size: 0.016 inches