Insta360 Go 2 Sleeves for BQE Micros

thingiverse

JUNE UPDATE: Some pilots have found that the original mounts caused jello in the Insta360 Go2 footage, and after some testing we believe it is because the lens was not isolated from the attachment point. I have just uploaded 3 new SLIM mounts that do not have the lens protection ring, and our initial tests show that this should eliminate the jello. Give them a shot and let me know what you think in the comments below. These BQE original camera sleeves for the Insta360 Go 2 camera incorporate a 10mm standoff for easy mounting on the BQE Pickpocket, BQE RIP Squeak, and BQE 3AF/3AFXL frames. Files labelled "wsupport" have built in support pieces but may require additional supports depending on your printer. The forward position model is great for frames like Ripsqueak and 3AF where you want to push that camera up forward more. The upright is a little better balance for Pickpocket type canopy frames. They should be printed in TPU, and require a 10mm standoff and 2 m3 mounting screws. You can grab the frame specific mounts here: RIPSqueak: https://www.thingiverse.com/thing:3690392 3AF/3AFXL: https://www.thingiverse.com/thing:4366794 The Insta360 Go 2 camera is available here: https://www.insta360.com/sal/go_2?insrc=INR2Q9I Looking for the mounts for the Insta360 Go 1? We have those too: https://www.thingiverse.com/thing:4366702 You can buy these frame and accessory kits at https://BQE.io