Insignia 4- Port USB 3.0 Mount-Holder-Sleeve

thingiverse

I hold a USB mount for my Insignia model NS-PCH5431 USB 3.0 hub in place. The design aims to keep cables organized and prevent clutter from building up around my workspace, especially since my hub was previously just sitting on the floor without any structure. This mount could also be useful for securing a desktop setup. The print settings I used on my CR-10 were straightforward, as it prints without supports in Cura. To ensure stability, I would recommend using higher infill percentages to avoid weak points in the design, but you might get away with lower settings depending on your specific needs. The mount is intended to be screwed directly into a desk surface, but it requires predrilled holes since it lacks mounting holes itself.