Inmotion V10 studded footplate - full print

thingiverse

Comfortable and high grip Inmotion V10/V10F inserts (footplates) compatible with new pedal design as of 2022. I have driven 3000 km on it without problem and it saved me of a few faceplants that happened before due to slipping on wet rubber footplates. 17x M4 DIN913 8 mm - 10 mm (depends on stand off distance) screws are recommended for each insert. Using up to intermediate taper for each hole is highly recommended. Two screws at front and rear might need to be shortened to achieve flat surface from inside. Double sided tape might be needed to secure the insert in place. To protect the EUC plastic cover, it is recommended to use either HEX screw or some other dull option like a rubber buffer It is highly recommended to use a grip tape with this design. It is possible to glue it after creating the tapered holes. To cut it, use a hammer or some other steel tool to rub and damage the sand out of outlines of the footplate. Then it is possible to easily cut the footplate with an utility knife. To create holes in the sandpaper I recommend using a sharpened DIN914 screw. Other less time consuming technique for grip tape gluing that yields better result would be to punch the holes before applying the grip tape. Special thanks to Jan Zopper Ťulák for 3D printing and testing.