Inmoov ServoBed V6 and Tensioner Modded

thingiverse

Servo Bed and Tensioner for "Inmoov" Forearms v6 -Modded- This mod involved removing the open-air print zones where it was printing with nothing under it. This mainly occurred in the Servo bolt hole positions. The Tension Bed has been reworked into one piece with the "Front Cable Mount." There is also a two-piece version available. There's no change to the overall design, or Servo bolt positions - you'd think it's the same as the original if you didn't look closely. It's just had a lot of panel beating done to it, making it a clean print with no cleanup required. Getting it to print cleanly was a challenge. Three 12mm-deep bolt/screw holes have been added to the Tension Bed and Main Servo Bed for easy installation. All servos are mounted using 6-gauge, half-inch, pan-head, self-tapping screws - they're a perfect fit for the servos. Remember to heat the screws before tapping them in. Bolt holes on the Tension Bed are 12mm deep. SketchUp files are included with this mod. Special thanks go out to "Mr Gael." *Note: I use Square M3 nuts on 90% of my objects - they're far better than standard hex nuts for 3D printing in many ways.*