Ink stamps for children - lower case a-z, 1-10, 25mm

prusaprinters

25mm square stamps - 3mm base, 3mm raised stamp. Printing in the softest flex you can is preferred, as it makes it easier to stamp - though even PLA will work if carefully pressed down.The printing surface needs to be sanded flat before use to remove layer lines and provide a good surface for ink - I used wet & dry at 240 then 600.I glued the stamps on to 25mm wooden cubes.Letters are not positionally accurate (lining the stamps up, letters will not be aligned vertically), I valued letter size on the stamp over position. The font used fitted the way letters are taught here but may differ elsewhere.The technique to create your own stamps is obviously quite easy - I exported a DXF from illustrator and extruded in fusion 360, but you could even automate it somewhat with openSCAD.