Ineos Grenadier speaker tweeter mounts, door top. Rev G9.5,9.6

thingiverse

For Ineos Grenadier front door aftermarket speakers with separate tweeters. No cutting, gluing, screwing, taping needed.These are designed to suit the tweeters from Alpine car audio component 2 way speakers, but will likely fit other tweeters too. the specific Alpine model was S-S65C.They are designed to be printed upside down so that the cone shape has concentric layers and there are no supports needed. Those in the photos used standard PLA filament on standard speed on a cheap Flashforge printer.I tried using ABS, which would have had a much nicer finish but it detached from the build plate. If I redesign it I will work on improving this aspect.I designed this as a temporary solution, but it's been working for a while happily.The half tube extension bit is to hide the cable. Thisis quite long on the left, and should be trimmed to fit during installation. I had to remove about 22mm, but you can see I left some wire exposed. Trimming to follow the window edge should hide it better.Note that the Ineos Grenadier door trim has a taper; it gets wider as it goes towards the rear. therefore, these are fitted by locating forward and sliding backwards until snug. Ideally. If you are doing it with the trim installed you may push it down but it will bend and scrape the trim. the plastic could break, though it didn't for me.