Inductrix FPV Tiny Whoop case

thingiverse

This awesome case was designed and printed specifically for the new Inductrix FPV. It holds the Inductrix, twenty batteries, seven USB chargers, and has a slot for miscellaneous cables and tools. The lid features a large Tiny Whoop logo on it. I'm unsure about the clearance for other camera configurations with antenna, etc. The lid's clearance is thirty millimeters, and the Inductrix sits at a height of twenty-five millimeters in the base. If your quad is less than fifty-five millimeters tall, it should fit without any issues. Print Settings Printer Brand: FlashForge Printer: FlashForge Creator Pro Rafts: No Supports: Yes Resolution: 0.2 Infill: 25% Notes: This case was printed with PLA on a FFCP using S3D software. With these models, the base and lid fit perfectly. The settings are listed below: Lid: -Print time is around eleven hours -Print the Whoop logo to the bed -Nozzle temperature is 225 degrees, bed temperature is sixty degrees -.4 nozzle diameter -25% infill density -Use support under the logo with a density of 25% -Three solid top layers, three solid bottom layers, and two perimeter layers -Turn on 100% fan after the second layer Base: Print time is around sixteen hours -Print the base directly on the bed -Nozzle temperature is 225 degrees, bed temperature is sixty degrees -.4 nozzle diameter -25% infill density -Three solid top layers, three solid bottom layers, and two perimeter layers -Turn on 100% fan after the second layer