Inductive / Capacitive Sensor Bracket for Cobblebot

youmagine

This sensor attaches directly to the Y-carriage of the printer, specifically to the bottom part. It's engineered to accommodate the bracket either on the front or back of the carriage and navigate around the hotend mount. Replace one of the M5x25 screws holding the wheels with an M5x30 and place the bracket on top, then secure it with a nut below. Since I created only a "left" model, if you want to attach it to the right side, you'll need to modify the design by flipping the upper part of the bracket. I printed mine in PLA using 20% infill and one perimeter at a .2 layer height. You may prefer to flip the model so that it prints on edge on your printer. In my case, support material wasn't necessary for the holes. The original file is available in FreeCad format.