Indicator holder for bed leveling and offset
thingiverse
This holder fits for 37mm Indicators, after printing it you should be able to press fit your indicator in it, after that i recomend to heat your buildblate to a 100 degrees celsius and put the part in standing orientation on it, this prevent a flat ground. To calibrate the dial indicator i took a caliper and set it to 80mm (this depends on the lenght of your indicator) and set the needle to zero after that i homed my printer (G28 X0 Y0 Z0) then i rised the Z-axis to 80mm (G0 Z80) And then I started the manual bed leveling mode on my Tenlog TL D3 Pro, but you can manualy drive your X and Y Axis to the corners Put the nozzle under the indicator and adjust the screws untill it show zero after this your bed should be leveled and your Z-Offset should be point on. note: if your Z-offset is off it might be your steps per mm in the Z-Axis
With this file you will be able to print Indicator holder for bed leveling and offset with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Indicator holder for bed leveling and offset.