In-line Fuse Block for Anderson Powerpoles

prusaprinters

<p>An in-line fuse block, fusing both positive &amp; negative lines, for circuits using Anderson Powerpole connectors. &nbsp; 0.25" female spade terminals are used for the fuse holders. &nbsp;This model uses standard bladed fuses, not mini.</p><p>Short lengths of wire are crimped to the Powerpole contacts. &nbsp;Connector pairs are assembled and inserted into the model body with wires passing through the fuse holder cutouts. For ease of assembly, orient Powerpole connector pairs so that the same color is aligned with the same side of the model. &nbsp; Trim the wire to the shortest length that allows for stripping &amp; crimping the spade terminals. &nbsp;Press fit spade terminals until flush with model top. &nbsp;</p><p>Depending on printed calibration, a small amount of CA glue applied to the back side may be desirable to ensure components stay in place. &nbsp; Be sure to NOT contaminate terminal contact surfaces. &nbsp; The same may be desirable for the Powerpole connectors, but normally is not required as the opening is shaped to engage the grooves in the connector sides.</p><p>Once everything is properly oriented &amp; secure, the B part lid can be attached with a few dabs of CA glue.</p><p>&nbsp;</p><p>v2 version is 10mm longer for easier assembly</p>