ImpulseRC APEX 5 Easy snapping collection (arm, bumper antennas, camera)

thingiverse

I was not happy with the abs parts and i don't like motor and frame screws to pinch on tpu as i'm not able to tighten those as it should be. I took inspiration from the works of sidler, Dr_AlexPID and the Team Mistral FPV of whom i really liked the work but wasn't on spot to what i wanted so... here it is my collection! - Arm protection and landing pad all in one snap on It's held in place with a peg like Dr_AlexPID (https://www.thingiverse.com/thing:4795443) but give complete protection to the arm tip likesidler (https://www.thingiverse.com/thing:4570038) - Rear TBS + VTX antenna holder A holder for both the TBS immortal T antenna which now is lower and further apart from frame and the pigtail from the VTX. Avaliable in three versions for impilseRC hex posts and standard round posts with 3 holes VTX pigtail and for hex posts 1 hole vtx pigtail (it has an hex slot for the pigtail so it won't turn when you tighten the nut). - Front snap on bumper This bumper leaves the bottom screws free to be tightened and clips onto the frame using the first botton frame hole. It also slips on the front giving more protection than stock one. - Motor snapon protector After a couple of test i added a lip that run under the arm to be fixed with tape to the arm as in crashes, the lever force generated caused the protector to tilt, it prints nicely upside down with tree supports (only buildplate), and is a snug fit. You need to mirror it to print a full set. - Camera mount base for ATH system I love the ATH system as it gives you the opportunity to swap camera and angle in a minute, with a firm hold. I designed the camera mount base according to the philosophy of the other parts, no bolt on. it slips on from the front of the top frame plate and secures to it for its shape. an additional zip tie can be used to be 100% sure it won't come off. Hope you appreciate the work! Comments and critics are welcome! !!UPDATES!! 2022.06.06 Added the slip on camera holder base for ATH system 2021.12.08 Added the Rear TBS + VTX antenna holder for 1 hole vtx pigtail version 2021.12.04 Updated the motor protector file with a better version 2021.12.02 Updated Snapon Motor Protector file as it was wrong, sorry! 2021.11.29 Added Snapon Motor protector 2021.11.21 v1.0 All parts have been tested and tested until ok to me, they go up the frame with really good tolerance and stay put no matter what. Going to design a version of the antenna holder for one hole version vtx pigtail sooner or later.