Improved SD Slip Case

cults3d

There is an even better version of this here: https://www.thingiverse.com/thing:5144211 For some reason cults3d is not updating my design. This is a much improved version of my earlier SD case found here: https://www.thingiverse.com/thing:4716706 The tolerances were too tight and the old one was often difficult to print so that the cards actually fit in the holes. This one uses a printed spring bar to hold the card in place. Note that you might need to push on it or cut it free with a knife after printing it, sometimes it sticks to the bottom. I have printed this on all my printers to make sure it works. The case is best printed standing on end. You might need a raft if the bed adhesion isn't strong enough. In case anybody is interested: yes, I'm working on an improved micro SD also. I even have a folding one almost ready that holds 8 SD cards and folds in the middle like a wallet. It prints as one piece.