
Improved Phone Stand for phone with popcap / battery case
prusaprinters
Improved design from the previous version (v6). This design is v7. Simple phone stand designed in FreeCAD to accommodate phones with popcaps and / or battery cases. Designed with iPhone 7/8/SE in mind in a slim battery case, both with and without a popcap. Should fit most phones. Your mileage may vary. Tested in portrait and landscape - popcaps were more or less centered. Also used with 9.7-inch iPad 4 (in portrait only). IF using with iPad, be careful not to topple. Phones may slide around a bit because the "hook" is large to accommodate phone+battery case. Channel on underside of feet is for glue-stick glue - for grip / non-slide. Print Settings Printer: FLSUN QQ-s Rafts: No Supports: Yes Resolution: 0.3 Infill: 15% Filament: Hatchbox PLA PLA White Notes: I used Cura 4.7.1 using "Tree" supports with a skirt. Extruder at 205 and bed at 65 running at 100 mm/s on the FLSUN QQ-s. This is the 7th iteration to accommodate placement of popcaps and provide for a relatively short print time. I print these in just under an hour. Post-Printing For non-slip feature, use hot glue All I did was squirt a bead of hot glue into the channel and then use a knife blade to press flat and shmoosh the hot glue into the channel. I put a very light coat of non-stick spray (just barely any) and spread it over knife face. I shmoosh the hot glue and hold the knife until the glue cools a bit, then the knife easily comes off and leaves the glue in the channel. The channel is supposed to keep the hot glue from peeling off - YMMV. Another option is Sugru or some other mouldable, rubbery substance. Category: Mobile Phone
With this file you will be able to print Improved Phone Stand for phone with popcap / battery case with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Improved Phone Stand for phone with popcap / battery case.